52 Allis Chalmers CA

Millie and I had a nice day in the yard today. I wanted to run the Allis since it's been laid up so long. My old phone camera doesn't do the fall colors justice even though I missed their peak last week while I was stuck at work.

52 Allis Chalmers CA

1100c Bedliner question

A dealer is prepping a 1100c for me. I have had a plastic bed liner in my 900 since new. It has earned it’s keep and has protected the steel from countless scrapes and bumps.

The dealer has been advised that since the new machine has a spray in bedliner, the plastic one will not fit. I really have been sold on the advantages based on my 18 years of experience of having this accessory. He has to order three per Kubota rules, and is unwilling to do so. So far I have not found another...

Read more

1100c Bedliner question

2014 x1140 Transmission Problems.

I am new to this forum... hello! I recently purchased an auction 2014 x1140. It was used by a golf course as a drink cart. The number of nip bottles and joint ends that i cleaned out of it would suggests that the operators were mostly drunk or stoned. The engine runs fantastically, but it does not move (it was cheap). I bought it knowing that I will need to put some $$ into it. I am not scared of doing the needed repairs, but i am hoping you guys can help me diagnose the problem.
This is...

Read more

2014 x1140 Transmission Problems.

Can't compress water

Water vs piston

Can't compress water

Wiring on RTV 1140

Need help finding a switched hot lead under the hood to connect a winch rocker switch to

Wiring on RTV 1140

RTV Daily uses, What did you do today with your RTV?

I finally got my RTV back from the dealer. While there fixing the linkage that slipped out of sync, I had a few other things done that by themselves were not worthy of a trip to the dealer. Left melted headlight fixed, fuel gauge replaced (it had been intermittent but turns out it was the gauge, no labor for replacing). I also had tubes put in the rear tires and I got the hand throttle yall had been talking about. Awesome.

So today I used the tractor FEL to load gravel in the RTV and...

Read more

RTV Daily uses, What did you do today with your RTV?

NH TC40DA cruise control magnet

Replacement magnets for this tractor are $286. They look very similar to mobile home trailer brake magnets that cost less than $50. Anyone tried using them?

NH TC40DA cruise control magnet