2638 hst impliment abilities

I just bought a 2638 hst.. excited.
My question is regarding impliment size. Can I safely use a 72" box blade?

2638 hst impliment abilities

Anybody use their RTV for recreational off road fun?

Most of the time my RTV is a work machine. Hauling firewood, rocks, dirt, and trailers seems more often than not. And it does a great job. If I get lucky once in a while I get to bring it to my brothers farm, about 54 acres, to give it a bit of a workout on some well groomed trails. But even there I'm limited to a couple of large loops, and small connector trails. Some of it is still wilderness and inaccessible.

Since 4 wheelers are prohibited in all public land where I live (Connecticut)...

Read more

Anybody use their RTV for recreational off road fun?

RTV Daily uses, What did you do today with your RTV?

I finally got my RTV back from the dealer. While there fixing the linkage that slipped out of sync, I had a few other things done that by themselves were not worthy of a trip to the dealer. Left melted headlight fixed, fuel gauge replaced (it had been intermittent but turns out it was the gauge, no labor for replacing). I also had tubes put in the rear tires and I got the hand throttle yall had been talking about. Awesome.

So today I used the tractor FEL to load gravel in the RTV and...

Read more

RTV Daily uses, What did you do today with your RTV?

It's here!

Now I just gotta mount it and hook up the power. That won't be for another week or so. This ought to make spotting my deer a little easier!

It's here!

Kubota RTV x1100c LED Light Bar

I've had my RTV x1100c for a few months now and I love it. I finally got around to adding some LED light bars. I searched quite a bit and found tons of different types, sizes, and mounting concepts from other people. I went with a 42" led (I think 960 W) on the front and two 4" floods (I think 54 W a piece) on the back. All came from Ebay. Some guys at work helped me with a mount for the front led. We came up with more of an "L" shape bracket that we bent to kind of conform to the curve of...

Read more

Kubota RTV x1100c LED Light Bar

Unprotected CV RTV500

I recently purchased an RTV500 2012 and only noticed last week that there isn’t any protection on the front drive shaft cv joint. It’s actually under the skid plate of all things and there doesn’t seem anything from Kubota to protect that area? Doesn’t make sense that a cv joint would be hanging unprotected on the belly like that. Either way the boot is ripped wide open now and this time I want to protect it it properly.

Unprotected CV RTV500

wai time

whats the wait time if i would go order a kubota rtv??

wai time

throtle stuck

just bought older model rtv 900 was ruuning fine . removed snow plow and engine ran at idle speed . pressed the petdal and throtle stuck wide open . any help to fix appreciated

throtle stuck

Received my 1120

Delivered on Tuesday. I have been familiarizing myself with the operating manual and so far I have put 10 miles on it driving around the property.

Received my 1120

TD55D stalling

Hello,

I have a NH TD55D which I have owned for about 20 years. Runs very well but now has a likely fuel supply issue.
The tractor was low on diesel then started to lose power. Refueled and restarted but it now stalls after a couple of minutes at all rev levels. I have checked and partly drained the fuel water separator and also the fuel filter and then primed to remove any air. Checked and cleaned air filter. I have ordered new filters for all of the above as they are overdue for...

Read more

TD55D stalling

GR2110 PTO

I have a GR2110 lawn tractor and the pto is out. It looks like I need a pto clutch kit.
Anyone out there done this repair I have a couple questions on how to get it out?
Messicks appears to be the cheapest to buy a clutch kit (expensive). Any other I should check?
Can I just replace the clutches instead of the whole clutch pack?
Any help appreciated!

GR2110 PTO

Reduced engine power after head replacement

History- 2005 RTV 900 1600 plus hrs. I've owned 5yrs. Lately I've noticed slight loss of coolant and discovered water pump leaking and small crack in head. Rtv ran fine with no loss of power or overheating. Replaced the water pump and a new complete head. Ran 30 min. let set over night retorqed the head and readjusted the valves on .006 ,flushed the cooling system, took th muffler off and cleaned it out, checked air filter.
Currently engine cranks and runs as it did previously but when you...

Read more

Reduced engine power after head replacement

CK20S kioti putting mahindra 3710 backhoe on kioti pto for pump???

I got a really good deal on a backhoe off 3316 mahindra tractor the backhoe is a 3710.. it is set up for a 33 hp 4.7gpm pump ,dont konow pto HP,I was wondering if i put a hydrualic pump on pto of kioti which has 16 to 17 hp on the pto will it be enough to run the hoe without tearing anything up like the pto. I dont have any problem fabbing and fitting the hoe to the kioti but i wanna use an external pump if i can just in case i tear something up i can still use the tractor and front loader...

Read more

CK20S kioti putting mahindra 3710 backhoe on kioti pto for pump???

No More Rattle

For the first time since we got the x1120, there are no more rattles.

As I learned from another member of the site, a couple of wraps of electrical tape on the tailgate pins cured that one. I later replaced it with black gorilla tape.

The SMV sign I have mounted on the rear screen was another source of rattle. The foam insulation I slid under one corner had departed and was rattlin right near my head.

The final rattle was coming from where the UTV Hitchworks transmission cover...

Read more

No More Rattle

Hydraulic Fluid Level - RTV-X1120

I admit it. I haven't checked the engine oil, transmission fluid or hydraulic fluid since December but I got around to it yesterday. My old Dad would curse me if he knew. The engine oil was good, in range and just down from the top. Transmission fluid was right at top of the mark. The hydraulic fluid, under the passenger seat, appears to be low. Since the fluid is clear, it was tough to see and finally had to get a flashlight to confirm. It is barely on the stick. I will pick up a gallon of...

Read more

Hydraulic Fluid Level - RTV-X1120

RTV X1100C Passenger Seat Back Removal

Stupid question time. When installing my seat covers couldn't figure out how to remove said item to secure the cover with the velcro strips...and there is no access behind it. When I installed my hitch extension/skid I looked at it again before leaving and still couldn't figure it out...but only spent a few minutes because it got cold real quick. Parts catalog "vaguely" shows 1 or 2 bolts securing it, but I just couldn't find them. Do I have to remove the interior back panel to access...

Read more

RTV X1100C Passenger Seat Back Removal

Strait pipe the Exhaust & Build a Cold Air Intake X1100C

I have looked at a few older threads (bordercollie and others) That show guys making a better high rise air intake for the RTV's.
Most of them for Dust reasons . I hear tell that a Diesel motor LOVES Air,, and likes to pass it like a big pump.
So.
I am interested in any help building a better air intake for the X1100c .
It appears to me that the factory LONG tube going to the front would cause major restricted air flow?

Also I do not believe in playing god on a diesel engine , Dont hot rod...

Read more

Strait pipe the Exhaust & Build a Cold Air Intake X1100C

Massey Ferguson 1135

Went to the Canada Day Tractor Trot on St. Joseph Island, Ontario yesterday. There are some restored show pieces but unlike most tractor shows, 90% of them just came off the farm field, still covered in mud and manure, they do the parade then go back to work.

I fell in love with this beast!!!

Massey Ferguson 1135

I have a leak.

Any idea what I might be getting into?

I have a leak.