Min brushless gimbal med Alex Moes controller er for langsom på roll, ikke når jeg rusker den frem og tilbage, men under virkelige forhold. Skal jeg skrue på P, I, D eller gøre noget helt andet?
Inscription à :
Publier les commentaires (Atom)
Popular Posts
-
Looking for a place to post loads hay hay I sold? CO to KY,TX,FL,TN,PA, and LA. Preferable free but not oppased to paying for the service.... -
Hi, There is a post pounder up in an auction tomorrow I am looking at. I was wondering if anyone has any experience with it. https:/...
-
Hi Sorry for the subject error, I can't seem to edit it.. i just finished doing a complete service on by BX23 and the RTV 900. It to...
-
i noticed that Jeep is suing to keep Roxor out of North America. i think one judge has ruled in favor of Jeep???:cuss: Roxor and Jeep squ...
-
My father-in-law has had a NH275 for many years and has worked without issue until this week. The chain that goes between the sprocket on t...
-
Does anyone have the K connect system on there 1100? Can you take the whole system off in the summer for more ground clearance? K connect
-
In another thread I shared that Im out of hay and have a couple good customers I want to keep stocked. I started looking for hay at a few lo...
-
My hardee 3pt sprayer control box quit talking to the sprayer. Box has power to it. Power comes from box, out the wires to plug to sprayer, ...
-
So we purchased a farm in deep East TX 50a in hay. Was not fertilized at al last year but sprayed for weeds. We made an "organic" ...
-
The shaft stripped out on my eaton Hydraulic pump. it also looks like there is damage where the shaft goes into the gearbox. I contacted...
0 commentaires:
Enregistrer un commentaire