Vermeer 554 XL Twine Arm Problem

lundi 22 septembre 2014

I need help with my twine arms, when extended to tie, they are actually hitting the bale near full extension, which causes them to jamb. I have to then free up the arms where jambed in bale. The lower tie arm was hitting the pickup teeth, so i adjusted up, and then the upper arm started hitting the bale. My tooth to starter roll clearance appears to be right a 3", as does roughly 2" from pickup tooth to ground. I must be missing something, but i just don't seem to be able to have the arms high enought to clear the teeth but low enough to not hit the bale. ?? Hay on the ground and i can't get anything done?? This baler is new to me, so I am trying to figure out what to look for???



Vermeer 554 XL Twine Arm Problem

0 commentaires:

Enregistrer un commentaire