I had damaged the driver side door and had it replaced under the insurance. The new door was damaged as well when they put it on. They had returned the machine and said they didn't see the dents. While waiting for the new door to come I had slid on some ice in March and damaged the passenger side door.
The Dealer came and got the machine and replaced the drivers side door again. It is not aligned properly. You have to slam it hard to get it to latch and then it moves almost 1/8 inch and rattles because it does not pull in tight. Looks like the pin on the post is a little low. Where do I adjust it? I can't see an adjustment and don't want to take something apart that I shouldn't. I am getting tired of the rattle and the door being so hard to get to latch.
Just as a side not, they returned it and the new door on the passenger side had a chip in it with rust already when they brought it back. They didn't notice it. They had the machine for almost 4 weeks.
It has been here for almost a month since the dealer returned it. I'm not sure what the dealers plan is. I know I have the insurance check and I am not signing it until I am satisfied with the work.
The Dealer came and got the machine and replaced the drivers side door again. It is not aligned properly. You have to slam it hard to get it to latch and then it moves almost 1/8 inch and rattles because it does not pull in tight. Looks like the pin on the post is a little low. Where do I adjust it? I can't see an adjustment and don't want to take something apart that I shouldn't. I am getting tired of the rattle and the door being so hard to get to latch.
Just as a side not, they returned it and the new door on the passenger side had a chip in it with rust already when they brought it back. They didn't notice it. They had the machine for almost 4 weeks.
It has been here for almost a month since the dealer returned it. I'm not sure what the dealers plan is. I know I have the insurance check and I am not signing it until I am satisfied with the work.
Kubota 1100C Door adjustment
0 commentaires:
Enregistrer un commentaire