New to me via auction JD 535 round baler. So far I just have the operators manuals for it. Starting to go through all the grease points, adjustments, etc... The gate latches are way out of adjustment. The manual says no bigger than an 1/8th of inch gap. These appear to be pushing 1". Possibly related but I'm not getting a ready/gate latched light on the bale trak either. Although the gate closed sensors appear to be aligned correctly. I do plan on actually measuring them per the manual but just eyeballing them, they seem to be in the correct spot. The hydraulic cylinders on the rear for the door do appear to be closed all the way.
Gate latches are both about this far
Gate sensor
JD 535, gate latches open too far
0 commentaires:
Enregistrer un commentaire