I am in the process of putting new billhooks and the billhook shafts on the baler. I've done the billhooks before and they were easy but never have tried to replace the shafts. It looks like the shaft is held by a roll pin that is attached to the gear drive. I've run through my operator's manual but no joy. If any of you have replaced the shafts, is it just a matter of getting the right sized punch and knocking the roll pins out? I've attached a photo of what I think is the roll pin. Appreciate any help.....
Attached Thumbnails
1980 JD 346 Wire Tie Baler Maintenance
0 commentaires:
Enregistrer un commentaire