BC5070 KNOTTER HELP (NEED PRO)

Bought brand new last year. I would say there are enough bales run through to wear the paint off. Had trouble since new. About 2000 bales through.

The side is always the right side looking from the back of machine.

Knot is always on twine #2 and not on twine #1

Trouble shooting guide states (twine holder spring tension too low)

I have adjusted as stated ¼ turn at a time. I have adjusted a full 1 ¼ turn so far. Looking straight down at end of spring gap. It started out about .125 it is now about .050. I adjusted both sides the same.

I lifted up knotter and took screw driver onto bottom of spring tensioner. To check spring pressure it is very firm. Also compared to left side knotter. They both seam close to the same tension.

Also possible cause is baling to tight. If I was truly bailing to tight wouldn’t the breakage be random? Not always on the right side?
Last baled was straw. About 34 inch bales about 25lbs. strings were pretty tight to get finger under. Side hay tension or wedges were screwed all the way in.

I baled 127 and 98 were good. So 29 were broken. Not acceptable to me.

When I unloaded wagon I found many specimens. The result was always the same. The right side only had knot on twine #2.
Big question???? Why did so many bales end up coming apart in wagon? Yes a lot broke apart in air to wagon. Always could see the bales let loose because only one string was on.

So is this a hint to when the string is coming apart?

Please Help! Thank you

BC5070 KNOTTER HELP (NEED PRO)