Vermeer TM800 Drive Cutter Unit

vendredi 25 mai 2018

Howdy! Had a lower gearbox seal out on main gearbox. Removed gearbox and double u-joint from gearbox and drive cutter unit. Had play in drive cutter unit and pretty sure it should not be that way. I think the hub is worn. I am going to try and post a photo to see if anyone here has dealt with this before. I was told the shaft had to be pressed out of hub. I removed screws #9 in photo to remove both hubs and gear that was held on by bolt. Looking at the pic how do you think I disassemble? Thanks for all advice!

Attached Thumbnails

  • Vermeer2.jpg


Vermeer TM800 Drive Cutter Unit

0 commentaires:

Enregistrer un commentaire