I have a NH 575 baler that has less than 10,000 bales through it and never missed a bale until today. The main crank that has the feeder forks attached it snapped the 1" shaft. My thought was that the pin on the end of the spring rod came out causing the whole issue because the pin connected to the bracket was gone when we stopped. Installed a new crank and pin put everything back together, turned over the PTO slowly and snap, the 1" shaft on the feeder crank that holds the forks broke.
I am completely at a loss as to why.
Any ideas would be most appreciated.
NH 575 baler - what is causing this ?
0 commentaires:
Enregistrer un commentaire