Pros and cons between JD and NH discbines?

I am looking for a rubber roller type discbine. It needs to be right at 10" wide and 540 PTO rated. I am pretty fixed on either a NH 7230 and a JD 630 MoCo. I will start. Pros on JD: #1 and the best, smaller single light weight u joint at tractor PTO. Very heavy CV shaft on NH,

JD less cutting blades to make a set.

JD parts are more available in my area.

JD dont seem to get a material build up under cutterbar ends

 

NH pros:

Seems to take less HP. (but does cut in streaks sometimes)

Alittle shorter over all.

Hood can be raised at any swing angle.

Cutterbar is more acessable under hood.

 

What else can you think of?

Pros and cons between JD and NH discbines?