I've got a New Holland 650 Autowrap that i got this spring. 2 things i am having a problem with. First thing is when i bought the baler the owner told me that for the first 10 balers or so for the year i will need to tie a rope on to the manual trip tie arm and pull it back to the up position once the bale ties. After 10 bales or so he said it would start doing it on its own. Well 60 bales in i still have to manually pull the arm back up.
Also a week ago i was baling some straw and had 2 things happen. The pickup got to full of straw and i had to manually pull it out, after baling again i tied a bale and got it out of the baler and started baling again. 2 things happened after this. I forgot to pull the manual tie arm back up and i noticed that the arms that run the twine though the outside of the bale and then back to the knifes were hanging down. one of them somehow got hung up on one of the feeder rods(bent up when i filled it with to much straw). I bent the rod back down and the bale tied but now the arms will not go all the way up to get into the knifes to cut. The knifes still open and close like they should.
Any suggestions? At this point i can get a bale wrapped but have to stop the PTO and manually cut the twine with a knife, also beings the arms wont extend all the way up like they should the twine doesn't reach the ends of the bale.
Thank you,
New Holland 650 Round Baler Tieing problems
0 commentaires:
Enregistrer un commentaire