Installing Skid Plate/Hitch Extension on 1120D

vendredi 8 septembre 2017

As you RTVX owners already know, the all-important receiver hitch is somewhat recessed under the transmission rendering it useless to some of us.

UTV Hitchworks has fabricated a piece that provides skid plate protection for the trans and extends the receiver to a useable position.

One note - that company recently started stamping its name in these pieces and I did not like that. I don't mind helping out a small outfit but it was just a little much.

Fortunately, I found one at my dealer that still has the manufacturer's sticker rather than the name stamped in the steel.

It was about $200 and I saw one banged up on ebay for $100 but I went for the new one.

I have attached the assembly pictures - it could not have been easier, just four bolts and I am very pleased with the outcome. One note - as you are inserting the hitch pin into the extension, it may be necessary for lift the piece up and down until the holes line up. So hold off tightening everything until last.

Among it other missions, our RTV will be used to pull a DR bush hog to keep that keeps our trails and meadows clear. The trails were wide enough for the Foreman but looks like we have some widening to do this winter for the RTV.

I hope this helps someone.

Attached Images
File Type: jpg 20170903_143103.jpg (82.9 KB)
File Type: jpg 20170903_143412.jpg (81.4 KB)
File Type: jpg 20170903_143419.jpg (56.3 KB)
File Type: jpg 20170903_144635.jpg (35.3 KB)
File Type: jpg 20170903_144745.jpg (61.9 KB)


Installing Skid Plate/Hitch Extension on 1120D

0 commentaires:

Enregistrer un commentaire