Hey guys, just joined on here and looking for some advice. Up here in central Iowa and trying to figure out what is not right with a Case IH 3650 round baler. It is a 1988. My dad bought this baler in 94 and has run a lot of bales through it. We went out and got a New Holland 688 a few years ago when we had the rear roller bearing go out. The baler has been fixed for some time but we haven't used it anymore, it was sitting in the shed. A buddy wanted to do some hobby baling, so I figured it would be a perfect fit for him. Well he got two bales made and all of the sudden the rear roller started binding and it popped the drive chain off. Everything spun freely by hand when we got it back together and like I said, he made two bales. The hex shaft on the right side is all chewed up, but I can't find where it chewed up against, the bearing on that side is brand new, the cast housing was used but shows no wear marks to match the hex shaft... it just doesnt make sense.
Nobody around here knows anything about balers. Just getting parts can sometimes be a nightmare. Anyone out there have a parts diagram for this baler or maybe some dimensions for what that rear roller should be?? I can get some pictures up here soon, just searching for anyone that has some insight.
Thanks in advance!
Case IH 3650 Baler Troubles
0 commentaires:
Enregistrer un commentaire