NH 1411 cutting height

mercredi 28 juin 2017

I have a new to me NH 1411 Discbine that is cutting too low.  This is with the hydraulic cutting height cylinder pinned in the highest position.  It should be cutting at around 3" and it is just about scalping.  I know I can adjust the cutter bar floatation, I just not sure if that will solve my problem and while the manual shows how to do it, it doesn't really say how to tell when it adjusted properly.  I am pulling it with a MF 4554.

 

Doug



NH 1411 cutting height

0 commentaires:

Enregistrer un commentaire