Hopefully a quick, easy question for Mike10 or others! Had the righthand lower roll bearing go out on my H7230 discbine. There is a plastic type spacer that goes on the shaft between the bearing and the end of the roll. I've attached a picture of it and it is flat on one side and angled on the other. Which direction goes towards the bearing, the flat or angled side? The original was chewed up pretty bad when the bearing gave way and I only recovered bits and pieces, so no help there for comparison. And the online parts diagram doesn't show enough detail as to which way it should face. Thanks for any help.
Attached Thumbnails
NH H7230 discbine roll bearing spacer
0 commentaires:
Enregistrer un commentaire